topshim error 84

i like this post (click again to cancel)

i dont like this post (click again to cancel)

remove favorite mark from this question (click again to restore mark)

I tried to perform topshim on my AV-300 but it say : "BsmsRCBSlope - setting RCB ramp failed - Error 84:BSMSExcessive Coil Power" during the run, and then fail.

What's the problem?

Thanks, regards

topshim

asked Oct 01 '14 at 02:37

Bourdreux Flavien
1

Are you doing 1D or 3D shimming? The RCB stands for "real-time control board" which provides fast ramping of the off-axis shims. The message says that you are putting too much power into your shim system. Contact Bruker. - Kirk Marat (Oct 14 '14 at 14:28)

One Answer:

oldest newest most voted

i like this answer (click again to cancel)

i dont like this answer (click again to cancel)

I think that the answer on this question can be provided only by Bruker support team. This code is incomprehensible for normal user.

I don't know what this acronym RCB could mean, reasidual circuit breaker ? First question is that your probe can be shimmed by automatic procedures ?

link

answered Oct 06 '14 at 02:14

Arkadiusz Leniak
238

updated Oct 06 '14 at 02:27

Here (once you log in) you will be able to sign up for the periodic email updates about this question.

Your answer

Please start posting your answer anonymously - your answer will be saved within the current session and published after you log in or create a new account. Please try to give a good answer, for discussions, please use comments and please do remember to vote (login to vote)

toggle preview

Tags:

topshim ×4

Asked: Oct 01 '14 at 02:37

Seen: 3,750 times

Last updated: Oct 14 '14 at 14:28

Related questions