halt command in topspin 3

i like this post (click again to cancel)

i dont like this post (click again to cancel)

remove favorite mark from this question (click again to restore mark)

Hello all nmr wikier last week we have upgraded software topspin2.1 to topspin3 on bruker av400 machine.when we use halt command within multizg the next experiment didn't run while spooler is on I mean the current experiment halted with fid save but did didn't run next experiments in the quee and finshes with multizg finish while on periviously version it run automatically the next experiment in the quee on halting.Does any body knows where is the problem.(spooler is on enable in setres)

signal-to-noise

asked Dec 01 '11 at 07:43

feroon
21

One Answer:

oldest newest most voted

1	Do not mix multizg and auto spooling. The spooler is intended to replace multizg. It might also work if you start mutlizg with "noqu multizg". Then the command does not go into the queue. link answered Dec 02 '11 at 13:10 Clemens Anklin 416

Here (once you log in) you will be able to sign up for the periodic email updates about this question.

Your answer

Please start posting your answer anonymously - your answer will be saved within the current session and published after you log in or create a new account. Please try to give a good answer, for discussions, please use comments and please do remember to vote (login to vote)

toggle preview

Tags:

signal-to-noise ×7

Asked: Dec 01 '11 at 07:43

Seen: 6,606 times

Last updated: Dec 06 '11 at 11:09

Related questions