Tuning probe failed after a dual probe was replaced with a BBI probe

i like this post (click again to cancel)

i dont like this post (click again to cancel)

remove favorite mark from this question (click again to restore mark)

We generally use Dual to run 13C and BBI to run 2D. After changed the probe, the command "edhead" was used to set the probe. Put the sample tube, lock the solvent, and then type "atma" to tune the probe. We always do it like this, but now we can not tune the proton after installed the BBI probe (13C is OK). The dip can not be found by "atma", and "atmm" was also not work on forming a dip. What is the most possible reason for this error? How to solve it and avoid it in the future ? Thanks. (Instrument: Bruker 400 MHz, Topspin)

probe-tune-match

asked Aug 22 '11 at 22:57

Yaming Xu
1

Most common error after a probe change is an incorrect cable connection. Double check the cable routing to be sure each probe coil is connected to the correct preamp. - Jerry Hirschinger (Aug 29 '11 at 06:28)

2 Answers:

oldest newest most voted

i like this answer (click again to cancel)

i dont like this answer (click again to cancel)

Use the standard sample for probe testing. lossy sample may cause mismatch
Please check the cables from HPPR to the probe, especially connections at the probe. It's convinient to observe signal via wobb (set wbsw 10-15 MHz). If anything changes, try to find out what's wrong with the cable. If not, try to replace cable, from X-channel for example.
try to connect previous probe and check wobb

link

answered Aug 28 '11 at 22:02

VVK
61

0	Did you try to manually tune the probe. I don't know how the algorithm of 'atma' works but it might be such that your probe has become hugely detuned and those protocols are not working. link answered Aug 31 '11 at 14:02 Paul 1

Here (once you log in) you will be able to sign up for the periodic email updates about this question.

Your answer

Please start posting your answer anonymously - your answer will be saved within the current session and published after you log in or create a new account. Please try to give a good answer, for discussions, please use comments and please do remember to vote (login to vote)

toggle preview

Tags:

probe-tune-match ×3

Asked: Aug 22 '11 at 22:57

Seen: 4,162 times

Last updated: Aug 31 '11 at 14:02

Related questions