i like this post (click again to cancel)
1
i dont like this post (click again to cancel) remove favorite mark from this question (click again to restore mark)

I've received a loaner probe from Bruker while ours is being repaired but I'm not getting any timely response on instructions on calibrating it for use. Anyone have a resource or documentation?

Thanks,

Ken

asked Jun 15 '12 at 12:58

Javaslinger's gravatar image

Javaslinger
53


3 Answers:
i like this answer (click again to cancel)
1
i dont like this answer (click again to cancel)

If it is the same type of probe that was replaced, then you only need to tune and match each channel to use it. The pulse widths and power levels from the original probe should be close enough.

link

answered Jun 18 '12 at 10:07

Jerry%20Hirschinger's gravatar image

Jerry Hirschinger
199

i like this answer (click again to cancel)
1
i dont like this answer (click again to cancel)

Ok, I take back my negative post regarding Bruker tech support. In the end they were tremendously helpful and walked me right through it.

link

answered Jun 21 '12 at 20:48

Javaslinger's gravatar image

Javaslinger
53

@Javaslinger - the posts can be edited so you can remove whatever content you dont' like. Thanks. - Evgeny Fadeev (Jun 21 '12 at 21:03)

i like this answer (click again to cancel)
0
i dont like this answer (click again to cancel)

What type of probe is this?

link

answered Jun 21 '12 at 15:11

Clemens%20Anklin's gravatar image

Clemens Anklin
416

Your answer
Please start posting your answer anonymously - your answer will be saved within the current session and published after you log in or create a new account. Please try to give a good answer, for discussions, please use comments and please do remember to vote (login to vote)
toggle preview

powered by CNPROG