Calibration of a Bruker NMR probe

1	I've received a loaner probe from Bruker while ours is being repaired but I'm not getting any timely response on instructions on calibrating it for use. Anyone have a resource or documentation? Thanks, Ken bruker asked Jun 15 '12 at 12:58 Javaslinger 53

3 Answers:

oldest newest most voted

1	If it is the same type of probe that was replaced, then you only need to tune and match each channel to use it. The pulse widths and power levels from the original probe should be close enough. link answered Jun 18 '12 at 10:07 Jerry Hirschinger 199

0	What type of probe is this? link answered Jun 21 '12 at 15:11 Clemens Anklin 416

i like this answer (click again to cancel)

i dont like this answer (click again to cancel)

Ok, I take back my negative post regarding Bruker tech support. In the end they were tremendously helpful and walked me right through it.

link

answered Jun 21 '12 at 20:48

Javaslinger
53

@Javaslinger - the posts can be edited so you can remove whatever content you dont' like. Thanks. - Evgeny Fadeev (Jun 21 '12 at 21:03)

Here (once you log in) you will be able to sign up for the periodic email updates about this question.

Your answer

Please start posting your answer anonymously - your answer will be saved within the current session and published after you log in or create a new account. Please try to give a good answer, for discussions, please use comments and please do remember to vote (login to vote)

toggle preview

Tags:

bruker ×75

Asked: Jun 15 '12 at 12:58

Seen: 7,478 times

Last updated: Jun 21 '12 at 21:03

Related questions